Punching pile driver due to the beauty and corrosion resistance of stainless steel. After degreasing, impregnation, activation, pre nickel plating and electroplating of stainless steel, it is possible to liberate operators from tedious and repeated physical labor. Through the mechanical modification of the original manual control system of punching pile driver, and using microcontroller and other auxiliary components, an automatic control system of punching pile driver is designed. The actuator of the original manual control system of punching pile driver mainly includes clutch control lever and brake control lever.

When the punching pile driver is refitted, the fixed block and the motor guide rail are fixed on the base of the pile driver, and the motor rotates to drive the lead screw to run along the guide rail. The DC motor is used as the actuator to control the brake clutch control rod. The microprocessor controls the rotation of the DC motor according to the position information transmitted by the position sensor. The motor rotates the lead screw to drive the control rod to move, so as to realize the automatic control of brake and clutch.

The installation of the punching pile driver will cause the sinking of the punching pile driver during the working process. Due to the on-site environmental problems, the site cannot be flat and solid. However, the external environment we mentioned here is a major influencing factor. Therefore, the foundation shall be treated during installation, and then sleepers shall be paved to ensure the stability of the punching pile driver during operation, so as to avoid the punching pile driver.